LIN OUT is already set at 1. The Microphone level set and extra
attenuator steps in W7 are not active until you plug a microphone
into the MIC jack and has no effect on the K3S internal sound card whuch
shows up as its own COM device.
Hank K7HP
Message: 9
Date: Wed, 3 Apr 2019 17:29:58 -0500
From: Bob McGraw K4TAX <
[hidden email]>
To:
[hidden email]
Subject: Re: [Elecraft] K3S USB sound card -W7 pro
Message-ID: <
[hidden email]>
Content-Type: text/plain; charset=utf-8; format=flowed
Also, in the Windows 7 sound card? make sure your don't have Microphone
Boost checked.??? Forgot about that one.
73
Bob, K4TAX
On 4/3/2019 5:21 PM, Bob McGraw K4TAX wrote:
> If you go into the K3S CONFIG menu to LIN OUT the normal value is
> 10.?? I suggest you back this down to 5.? This will then allow the
> Windows 7 Pro sound card slider to operate near mid range thus? 0 dB
> or 50% depending on how it is displayed.
>
> 73
>
> Bob, K4TAX
>
> On 4/3/2019 4:50 PM, HP wrote:
>> Is here any way in W7 to change the RX level when using the built in
>> USB K3S sound card . The W7 slider
>> goes to -10dB with a lot of care but next tap is -192 dB- In WSJT
>> this means I have LIN out set to 001 and its. still a bit too high .?
>>
>> Hank K7HP
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
