I have been corresponding recently with Dick Dievendorff about this. I
am looking into allowing K3 Utility to work through LP-Bridge. The issue
has to do with K3 Utility needing to be able to change one of the meta
commands in the K3, which is normally blocked by LP-Bridge to prevent
multiple applications from independently changing meta commands which
might conflict with other apps.
If I do this, it will add a check box for the VPort where K3 Utility is
connected, and I would still strongly recommend that flashing of new
firmware NOT be done through LP-Bridge.
73,
Larry N8LP
Date: Thu, 18 Feb 2010 11:01:57 -0800 (PST)
From: Bob - W0GI <
[hidden email]>
Subject: [Elecraft] K3 Utility and LP-Bridge - Correction
To:
[hidden email]
Message-ID: <
[hidden email]>
Content-Type: text/plain; charset=us-ascii
While setting up LP-Bridge, I assumed the the K3 Utility would work ok as
"Test Communications" worked ok, and the firmware page was showing my
versions. But I have found other functions do no work.
Looking at the LP-Bridge page I found this.
"Some commands are intenionally blocked altogether. For this reason, the K3
Utility should not be used with LP-Bridge."
Mommy always told me to read the manual first. :>)
That said, my previous posts on using K3Util with LP-Bridge are incorrect.
--
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
