In a message dated 5/10/2012 3:10:33 P.M. Eastern Daylight Time,
[hidden email] writes:
The K3 was still receiving fine at
the reduced voltage (my low voltage is set at 11V), but the 232 port
clearly was not.
That's similar to the experience I had when operating mobile/rover using a
separate AGM battery whose level was somewhere below 12.5 VDC (if I recall
correctly). I haven't had time to pursue the problem with Elecraft tech
support. Clearly, I'm not alone saying the RS-232 port on the K3 sometimes
doesn't do well below a certain voltage, yet the remainder of the K3 runs just
fine!
Bert, N4CW
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
