Re: K1 no output on 20 - KFL1-4 problem?

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

Re: K1 no output on 20 - KFL1-4 problem?

kl7r
Very interesting Greg,

I can hear some signal on 20 but weak.


Sounds like we have identical problems,

I wonder what could have caused 20 to go out?
 
The K1 was on the shelf for a couple of months and was
working fine when I put it up.  I dont think I did
anything dumb to cause it to stop working.

It is interesting that others have seen identical symptoms.
I'm going to take a few DC voltage measurements and see what I see.


Mike



>I'd sure be curious if you find out what is causing the NO output on 20
meters. >I'm experiencing the same problem and have been doing so for some
time. I've >done a lot of trouble shooting as well but to no avail.

>Do you receive signals on 20 meters? I do.
>If I plug in the two band (40 and 20 meter) board all is well on 20 meters so
I >know the problem lies with the KFL1-4.

>In signal tracing I have signals from both 1 and 2 of T1 (pin 1 and 2
>respectfully on P1) but when switch to the 20 meter band these readings are
>considerably lower than the readings for the other bands. On pin 2 of T2 I
have >no readings for 20 meters but good readings for the other three bands.
Pin 4 of >P1 likewise shows no signal for 20 meters.

>I've checked the board for shorts as well as maybe a bad solder joint but all
>looks good.
>Oh yes, my 4 band board worked good for quite a spell before loosing 20
meters. >This looks to be a problem experienced
>by several of us that have purchased the KFL1-4 board.

>I'm looking for a solutions as well and would appreciate input from anyone
with >an idea. Or, help please.

>72,
>Greg
>KI8AF


 
____________________________________________________________________________________
Do you Yahoo!?
Everyone is raving about the all-new Yahoo! Mail beta.
http://new.mail.yahoo.com
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com