Curron HILL wrote:
>
> "has anyone tried one of these on the K1 to help with the tuning rate?
>
http://www.oselectronics.com/ose_p101.htm"
>
> We you referencing the *Vernier Dials?*
> * *
> I think they would not work. I believe they only work with capacitor
> tuning circuits where you are only turning the shaft 180 degrees. The
> k1 uses a 4 turn pot (I seem to remember, could be wrong) so you would
> only be able to tune 1/8 of the K1 range.
>
> Now if you could find one that gave the geared reduction and did not
> stop at 180, but rather kept going, then you would have something and I
> would install one as soon as it arrived. I wonder does anyone make
> something like that?
>
I just received a reply from tech support at oselectronics....
the VD61 is a continuous 360 degree turns 6 to 1 vernier.
--
GB de ka5oai,
Sam Morgan
--
linux - the lifetime learning experience
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
