Re: K3/100 KSYN3 Installation

[Eric Swartz - WA6HHQ]

Yes, the resistor is valid.

Have fun building!

73,

Eric  WA6HHQ
_..._
-----Original Message-----
From: "Walter V. Gilles" <[hidden email]>
Date: Thursday, Feb 12, 2009 12:12 am
Subject: K3/100 KSYN3 Installation
To: Reply-    [hidden email]: [hidden email]


Eric,
 
You ever sleep?  ;-)
 
Thanks so much for the info on the J73 pin plug.  By golly, on closer observation, I now see that the related hole for the clipped pin (P73-J73) is indeed plugged, and that would certainly "key" things up if one were to try to install the KYSN3 backwards.  I guess I'll just chalk that oversight up to too little light, too old eyes, and too late in the day for me.
 
As an aside, I also noticed a leaded resistor (maybe 1.5M ohm - old eyes again) soldered in between (near) C13 and C69 on the KSYN3 board.  I don't see this in any photos either.  Am I good-to-go with this little fellow added on?  Knowing you guys, I bet I am.
 
Thanks ever so much for your personal interest in helping me on this.  You guys have just one amazing enterprise there.  Thanks again.  73
 
Walter, N0DZJ
     


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html