Yes! I was about to ask how that was easier than using a PC - right on the
button Wayne!
On 30/8/07 21:19, "
[hidden email]"
<
[hidden email]> sent:
> Message: 27
> Date: Thu, 30 Aug 2007 07:41:53 -0700
> From: wayne burdick <
[hidden email]>
> Subject: [Elecraft] K3 DATA-mode setup is saved and restored
> To: Elecraft Reflector <
[hidden email]>
> Cc: 'Bill Tippett' <
[hidden email]>
> Message-ID: <
[hidden email]>
> Content-Type: text/plain; charset=US-ASCII; format=flowed
>
>>
>> W4ZV queried:
>>> Why wouldn't you store this setup in one of the Mx
>>> memories? I assume it may have to do with the above
>>> parameters not all being available to store, but that's just
>>> a little more flash memory isn't it? :-)
>
>
> Ed, W0YK, described the entire setup procedure for getting on
> CW-to-RTTY with the K3. I just wanted to clarify that all of those
> settings *are* saved in non-volatile memory, just like every other
> setting in the rig.
>
> So, having set DATA MD to FSK, selected a mark pitch, and turned the
> text decoder ON, Ed could turn power off, switch modes, etc., and come
> back to these settings just by being in DATA mode.
>
> 73,
> Wayne
> N6KR
--
The high minded man must care more for the truth than for what people
think. -Aristotle, philosopher (384-322 BCE)
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
