As it turns out the issues are mostly related to my antenna and operator
error... e.g. not knowing how to correctly use the DSP/AGC/Filters/RF
gain.etc..
Rig is working 100% PEBKAC error ;)
Jerry Moore
CDXA, INDEXA, SKCC, Fists
AE4PB, K3S - S.N. 010324
http://www.qrz.com/db/AE4PBAn Amateur is - Considerate, Loyal, Progressive, Friendly, Balanced, and
Patriotic.
-----Original Message-----
From: Elecraft [mailto:
[hidden email]] On Behalf Of dw
Sent: Monday, October 12, 2015 2:03 PM
To:
[hidden email]
Subject: Re: [Elecraft] K3S Radio check? (signal generator)
I used a simple 4-pin clock-oscillator running at 7.32mhz.
Runs on 5VDC.
Put it in a project box with LM7805 and a 12 inch wire as antenna.
Can't use that as a signal generator for circuit tracing though without
seriously limiting its output.
But it makes for a simple little qrp xmitter.
With nothing attached to K3 ANT1 input, lay the wire next to the K3.
Picked up the signal S9.
Hope you find the issue Jerry.
--
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html Message
delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]