I wrote previously:
"I've done what you're talking about with CT but not N1MM."
I haven't used CT with serial port keying for 6 years so the memory
is a little hazy. Turns out you can't have the rig control and
keying on the same serial port with CT. You can run them on separate
serial ports, which is what I did back then. Once I got two K2s
I used parallel port keying.
You should still be OK with N1MM. Make sure you are connecting your
keying interface to pin 4 and 5 at the computer end of the serial cable
and only pins 2, 3 and 5 are connected at the KIO2 end of the cable.
73
Gary, N7IR
K2 1078, 2154, 3463
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
