Re: KPA100/KAT100 in EC2 and KAT2 (was: Barebone K2 Amplifier?)

[Geert Jan de Groot-3]

On Fri, 8 Dec 2006 04:03:03 -0500 (EST)  [hidden email] wrote:
> If only the firmware could determine when it was connected to
> the KPA-100/KAT-100 or not and return control to the KAT-2.  
> (Sorry Wayne <g>.)

It kind of does.
Upon detection of a KAT2 (in K2 enclosure), and KPA100/KAT100
(in EC2 enclosure), the firmware will switch the KAT2 in through
mode (CALP), antenna port 1. Any tuning / antenna port selection will
only drive the KAT100.

Switch off the K2, disconnect, and your KAT2 will function as it
used to.

There's several minor glitches, though:
- The 2nd port of the KAT2 is no longer accessible.
  It would be nice to switch between ANT1 (KPA100/KAT100),
  ANT2 (KPA100/KAT100), and ANT3 (KAT2, port 2), so that the latter
  can be used for a transverter
- Under some circumstances, the KAT2 remains stuck in CALP mode
  when the KAT100/KPA100 is disconnected.
  It is easy to set it back to AUTO mode, you just have to remember.

Geert Jan

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com