The picture was rejected. Not a problem. See if the point is said
without the "extra" 1000 words... steve
On 2/18/21 8:58 PM, stephen shearer wrote:
>
> I have seen a difference in low end (audio bandpass) performance in
> the past, it was not a problem.
> I use DATA for FT8.
> I have had "issues" with FOX/HOUND as the FOX is often below 400Hz.
> With few DXpeditions, Fox/Hound has not been an issue.
> When I have tried Winlink VARA, I have problems as it also works below
> 400HZ.
>
> See: snapshot. DATA vs SSB... SSB is FLAT (0db), but note the signal
> is down to ~200Hz. (you can see when I switched between SSB and DATA.
> In DATA mode, it is ~350Hz (closer to 400Hz for flat data).
> (assuming photo made it past email server)
>
> Yes, I can re-set RX/TX EQ between DATA and SSB, I should not have to??
>
> Is this an Elecraft problem with settings (firmware) or is there a
> setting I missed? (to set DATA low end)...
>
> KX3 #3819 Firmware up to date.
>
> 73, Steve WB3LGC
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
