Let me second Nigel's request and recommendation; it is excellent well
supported software; I use it as well; the K2 serial interface cable
works well supporting the remote control options and passing frequency
and mode to the programs.
Aside from the microHAM products, it also does well with the rig blaster
series as well.
I do wish someone would make a proper cable set for the K2 to microHAM
microKEYER though; it would make it easier to get a nice portable setup
going...
73 de W5SV, Dave
Nigel wrote:
>I notice that the DxLab suite of programs, which fully supports the K2
>interface, is not listed in the list of software. I use it and find it very
>good.
>
>This is a freeware suite of programs with great support from an active
>community of users via an email reflector and a provided by a very pleasant
>and talented designer. Logging, Call sign Look up. Propagation
>prediction, Rotor drive, Spot collecting, MapView and Digital modes support
>plus CW sending are included. It also Interfaces well with MicroHam
>products.
>
>It can be found at
>
>
http://www.qsl.net/dxlab/>
>Perhaps it could be added to the Elecraft List?
>
>
--
David F. Reed - W5SV - cell: 512 585-1057
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
