Larry,
The toroid cores are non-conductive, so if the bare wire of the end turn is
tinned it is not a problem, BUT if you also bared the wire of an adjacent
turn so you could have a one turn shorted to another on the winding, that is
not good and you will have to rewind.
73,
Don W3FPR
> -----Original Message-----
>
> Hello everyone,
> On the 160M module, toroid L1 .I managed to burn off just a
> little too much enamel insulator from 26ga. wire.........Bare
> copper into the 1st 1/2 turn on the toroid.
> Am I o.k.? Or should I rewind?
> Tnx
> from new guy ,just starting out.
> W1EGJ
> Larry Wright
> _______________________________________________
> Elecraft mailing list
> Post to:
[hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft>
> Help:
http://mailman.qth.net/subscribers.htm> Elecraft web page:
http://www.elecraft.com> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.441 / Virus Database: 268.18.2/692 - Release Date:
> 2/18/2007 4:35 PM
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.441 / Virus Database: 268.18.2/692 - Release Date: 2/18/2007
4:35 PM
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
