From: David Anderson <
[hidden email]>
To: David G4DMP <
[hidden email]>
Cc: "
[hidden email]" <
[hidden email]>
Subject: Re: [Elecraft] Quick survey: Need a 0-dBm transverter
interface module for the KX3? (KXXV3)
David, I only expressed an interest in a product that Elecraft had
mentioned as a possibility. I don't have the luxury of a K3 or K2 and
the KX3. The KX3 is the perfect small rig for transverting to other
bands or would be if the small internal interface was available as an
option to go in the same space as the internal 2m transverter.
I may make one myself of I can get sufficient details from Elecraft.
David Anderson GM4JJJ
------------
David,
This has been on my to-do list but so far back on the list - well?
I can envision it small enough to enclosed in a DB9 backshell, though
it would be easier on a small pcb & box. I saved some info on pcb
interface transformers for the IQ baseband audio. To lower to -10 to
+10 dBm range would involve a chip load resistor and small coupling
cap with adjustable attenuator (two chip resistors and a small pot).
Would this be a 28-MHz IF or use the new 144-MHz module for
interface? Switching would be needed to bypass in Rx
If not installing the 2m module there might be room inside but not
sure the difficulty in making connections internally. Be easier to
make small box to attach with velcro to back of KX3 with very small
cables to normal connectors. 1/4-inch thick aluminum plate would
likely serve as heat sink for 10w 50-ohm termination.
This would also serve those wanting to run a panadaptor or other sw
on their computer.
73, Ed - KL7UW
http://www.kl7uw.com "Kits made by KL7UW"
Dubus Mag business:
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
