Good Afternoon everyone,
An update on my issue. I removed R19 from the circuit, measured the
voltage at RP2 pin 2 and found 0 vdc. I checked the frequency at TP3
and still find 12.602 MHz. Now I know the problem doesn't lie in the
thermistor board as the problem is still there even with the thermistor
board removed.
Although there is no obvious cold solder joints, I'm going to reflow the
joints as the only commment I've gotten from anyone that has looked at
the board is that I may have been a little skimpy solder.
Cheers
Terry
VA6MAC
************************************************************************
This e-mail message is intended only for the person(s) named above and
may contain confidential or privileged information. If you are not the
person named or have not been authorized by them to access their mail,
please notify the sender immediately and delete this e-mail and any
attachments without reading, saving, or forwarding.
************************************************************************
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
