Config -> LIN OUT -> tap REV/2 button. Use VFO A knob to adjust t= xxx to set transmit monitor level. 0 = none and up from there. Mine are set at 010. YMMV.
Ken K6MR
From: HP<mailto:
[hidden email]>
Sent: Wednesday, April 28, 2021 23:36
To:
[hidden email]<mailto:
[hidden email]>
Subject: [Elecraft] Record both RX signal and TX monitor in CW
Using AUDACITY and the K3S USB Audio Codec -recording received signals works fine-but is there a way to also record the TX monitor signal ?
Obviously I can run another computer running Audacity and simply record the speaker or headphone output
bit is there any way to avoid that ?
Hank K7HP
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
