Hi Jorge,
What you do is pull CAT over the internet using the COM2 port of the
RemoteRig.
If *not *using K3 Twin (i.e. software control only through the control
RRC), then this works just by using that software.
If you are using the K3 Twin, you need to change COM1 to mode-6 on the
control RRC, then you also have CAT duplicated over COM1. You then
connect your control software to the RRC COM1 and can use that for
anything as if the rig is local.
73,
Mitch DJ0QN
On 10.03.2012 20:52, Jorge Diez - CX6VM wrote:
> Hello,
>
>
>
> It´s possible to use the logging program, for example N1MM, to send CW and
> SSB messages from the local station or I must use the paddles and MIC
> connected to the local remoterig?
>
>
>
> Thanks,
>
> Jorge
>
> CX6VM/CW5W
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
>
> --
> Mitch Wolfson
> DJØQN / K7DX
> Georg-Kerschensteiner-Str. 42, 81829 Muenchen, Germany
> Skype: mitchwo - Home:+49 89 32152700 - Mobile:+49 172 8374436
> Echolink: 3001 - IRLP: 5378
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html