Removing the 160 board

[Gregg mulder]

Can somone one the list please tell me what components need to be removed to remove the 160 board from the K2 for troubleshooting?   Tns  Gregg WB8LZG
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Gregg,

You do not need to remove anything other than the K160RX board itself.
Install a jumper (bent component lead) between pins 1 and 7 of J14.

In general, there is no need to remove the K160RX when troubleshooting
unless you suspect something pointing to the board itself.  It contains only
the 160 meter LPF and the connection to the RX antenna.

73,
Don W3FPR

> -----Original Message-----

>
> Can somone one the list please tell me what components need to be
> removed to remove the 160 board from the K2 for troubleshooting?
>  Tns  Gregg WB8LZG
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.17.0/639 - Release Date: 1/18/2007
6:47 PM

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com