Hello to the group.
I am having an issue trying to get my K3 Utility program (Version 1.16.7.25) to
connect to my K3s locally.
I am using a remote rig system and am attempting to program the K-Pod macros at
the control site. The Remote rig system creates three COM ports. I have COM 6 as
my CAT port. If I turn the K3/0 mini on and then launch my N1MM+ software, the
software connects to the K3s on COM 6 and I have CAT control of the radio.
When I then launch the K3 Utility program and select COM 6 even before
attempting to press the Test Communciations button, the top banner message I
see is : "Elecraft K3 Utility Revision 1.16.7.25 on COM 6 closed". I am almost
certain that I may have hit the Close Port button below the Test Communications
button at some point and then encountered this problem but not sure.
I have attempted to reset the Remote rig units, the K3s/0 mini as well as my
computer with no change. Not quite sure what to try next.
Any assistance would be appreciated. Please let me know if any additional
information is required.
Thank you in advance.
Serge
VA3SB
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
