Hi all I just completed the control board last night.
8.5 hrs to build. look at part, verify part, install
part verify again, then solder then check solder.
HI HI anyhow.
I did the resistance checks as perscribed in the
manual
Everything is ok but U6 pin 13 and 14 greater than
100k
well its only 85k any ideas before I dig in? The only
reference that I could locate in the builders resource
was to resistance checks with an analog meter I am
using a fluke digital little older but ok
Thanks David KR4OW
__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!
http://promotions.yahoo.com/new_mail
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
http://mailman.qth.net/mailman/listinfo/elecraftYou must subscribe to post.
Subscriber Info (Addr. Change, Unsub etc):
http://mailman.qth.net/subscribers.htmElecraft page:
http://www.elecraft.com
Locked
