SDRPlay + HDSDR on K3S (was RE: K3S 15KHz output?)

[Michael Schulz]

Has anybody made the SDRPlay with HDSDR work as a pan adapter using the IF
out? When I tried to use HDSDR
in IF mode, it complained that the IF frequency was too low (current version
of the driver), so I had to resort to
using the RX ant in/out with the SDRPlay, which works but is not the most
elegant solution.

73 Mike K5TRI

> -----Original Message-----
> From: Elecraft [mailto:[hidden email]] On Behalf Of Don
> Wilhelm
> Sent: Thursday, December 17, 2015 1:17 PM
> To: [hidden email]; [hidden email]
> Subject: Re: [Elecraft] K3S 15KHz output?
>
> Bob,
>
> No 15 kHz output, but better for SDR experimenting, use the IF output at
> 8.215 MHz.  That gives you a output that is prior to any IF filters in the

K3S.

> If you want baseband I/Q outputs, you can connect a softrock receiver or
> LPpan2 to that IF output.
>
> 73,
> Don W3FPR
>
> On 12/17/2015 3:57 PM, Bob Novas wrote:
> > Far as I can tell, there is no 15KHz output from the K3S that can be
> > used for experimenting with SDR. Is that correct? Thanks, Bob W3DK
> >
> >
>
> __________________________________________________________
> ____
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

Message
> delivered to [hidden email]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]