Hi Troy,
Questions:
1. Are you in SPLIT mode by any chance, with VFO B set to some mode other than SSB?
2. Do you have mic gain adjusted to the point of seeing 5 bars of ALC on the meter on voice peaks?
3. Do you have the SSB crystal filter's labeled offset entered in the CONFIG:FLn OFS menu entry?
4. If you set CONFIG:2-TONE to ON, exit the menu, and tap XMIT, do you see power output? (Turn it back off afterwards.)
5. Are there any error messages when you power-up the K3?
The answers to the above might help us figure out what's going on.
73.
Wayne
N6KR
On Feb 20, 2014, at 3:52 PM, "Troy,w6hv" <
[hidden email]> wrote:
> I have lost SSB again--however CW is still working fine. I can hear my microphone in the monitor. This happened once before and I used the K3 Utility and did the “Calibrate Transmitter Gain” and it restored SSB. However, I can’t get it to work this time.
>
> I re-set up the Mic Gain and Compression Settings. No luck.
>
> I’ve contacted Elecraft support and Howard has been trying, but so far no luck. Somehow I my config file must be wrong?
>
> Thanks for any help,
>
> Troy, W6HV
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
