Heh, that's funny, I just requested the same thing...
However, you can get several scan rates by using FINE, COARSE or RATE.
These give you aprox 150 Hz/sec, 1.5 KHz/sec and several kHz/sec, if I
recall.
I wouldn't mind having an intermediate rate between the two slowest
ones. One seems too slow and the other too fast. I don't use the
fastest one at all.
I also would like to have a fixed selectable dwell time on the muted
scan. Sometimes it pauses for a couple of seconds, sometimes for a lot
longer. I would just like to have it pause for, say, 5 seconds every
time it stops.
I use scanning on the CW bands, usually in unmuted mode with a very
wide filter. It's nice to be able to scan the bands while you're busy
with other stuff in the shack. A tap of the key stops the scan.
73,
Drew
AF2Z
On Fri, 05 Dec 2008 12:00:58 -0800, Bob N6WG wrote:
>Is there any adjustment somewhere to slow down the scan rate?
>Mine goes too fast, and by the time I hear a station the K3 has
>shot past it, and it's hard to get back to the station's frequency.
>
>Any info?
>
>Thanks and 73
>Bob N6WG
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
