5707 passed the 'alignment and test, part 1' checks with no problem and I'm
well into the 'Assembly, Part II' section. I'm at the point of installing
C91, C88 and RFC 15 on the bottom of the rf board at U4. The manual talks
about a miniature 100 uH choke, much smaller than the other 100 uH chokes and
with a tan body. I have 4 green bodied and one tan bodied 100 uH chokes as
indicated in the parts list, but the tan bodied one is pretty close to the
same size as the green ones, if any thing a little bigger. I'm sure I can
solder it to the indicated location, but is this something I should be
concerned about?
Thanks for any advice,
Bernie Gardner
W1AZ
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
