The K3 doesn't change its baud rate without some front panel action or PC
command. The K3 Utility determines the K3's baud rate by trying each of the
four supported speeds.
Dick, K6KR
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of Jack Colson
Sent: Monday, October 20, 2008 2:35 PM
To:
[hidden email]
Subject: [Elecraft] Solved: How to communicate with the K3 using N1mm
Well it is working, i presumed that the K3 would auto-baud with what
ever bit rate it was receiving. Not so, mine was sitting at 9600. Once
the two were set to agree, BINGO! Thanks to all - sorry I should have
looked at the config -rs232 on the K3 before asking for help.
73
Jack, W3TMZ
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
