|
|
Hi
In programming Win4K3Suite, I encountered a few few missing missing commands in the serial API and a couple of bugs.
The most important missing command is the ability to determine the shift of the sub-receiver. i.e IS$nnnn. It would be really good to have this to allow independent control of all of the filter settings in the sub-receiver.
The lack of an equivalent of TE for the receiver equalizer, makes it a bit problem prone to provide a receive equalization that is robust since you cannot read the values without resetting them to zero first.
Some nice to haves: Access to the NR settings, access to the manual modes of the notch filter, and state of the FINE and Coarse tuning.
Bugs: The P3 command #AVG00; turns off averaging of the spectrum on the P3 but not on the SVGA signal. This happens with the P3 utility or third party utilities.
The KPA500 serial commands to determine the power state are fairly reliable but not always. It is much better than the first firmware though.
Just thought I'd put out the comments.
Thanks, Tom
VA2FSQ.COM
|
Locked
