Gang: Need a little help to clarify the set-up on my XV50.
Page 72 of the manual gives initial set-up for the shorting blocks to
configure the transverter. In reading the text, I'm finding some
difference's based on my set-up.
I'm trying to TX/RX on a single antenna and using the K60XV for a low level
drive of 1milliwatt.
Some of you guys who are running this set-up please tell me if I'm on track.
Here's the set-up I'm using:
JP1 pins 1&2
JP2 pins 1&2
JP3 pins 1&2
JP4 pins 1&2 ( bypassing the attenuator )
JP5 pins 2&3
JP6 pins 2&3 ( enabling Q6 )
JP7 no shorting block installed
JP8 shorted
JP9 pins 1&2 ( I don't have the crystal oven yet )
This will allow me to run one jumper cable from the
" OUT " port of the K60XV to J3 " TX in / 1IF " on the
XV50.
The RXout / 2IF is then used to daisy chain to other transverters.
Command signals are via the AUX BUS and course the antenna hooks to the
transverter J1.
YES / NO ?? any suggestions ??
Thanks and 73: Jerry N0JRN
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
