Bob
I certainly could have done that. In fact, before I powered it up the
first time, I had done the same thing, but when I ran the K3 Utility, I
corrected my error. Thanks for the suggestion. To all: I am working with
Wayne and Gary currently trying to chase down the problem. Thanks
everyone for your suggestions and good wishes.
Bob
On 11/15/2010 11:25 AM, Bob Henderson wrote:
> Bob
>
> I had a similar experience for a few minutes during set-up of my new K3. In
> my case I had not installed a roofing filter at FL1, choosing instead to
> leave a gap there for later installation of a wider filter. The firmware
> default assumes a filter will be present at FL1 and the absence of one made
> the RX deaf and provided 0W RF out on TX. Once I had changed the default
> filter location, which I did using the Elecraft K3 utility, the RX came to
> life and TX Gain Cal ran just fine producing the required 5W output on every
> band.
>
> This might possibly be your problem.
>
> Good luck.
>
> Bob, 5B4AGN
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
--
73, Bob K5SM
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
