Well a problem just started. Regardless of where in the 20M band I am when
I shut down, it always comes up on the same frequency when I turn the rig back on. The same is true of other bands. Never happened before. Real strange. An example of this is I turn the rig on and say it comes up on 14.010. I tune up the band to 14.035 and turn it off. If I turn it back on immediately, it come up back on 14.010! Anyone got any ideas before I do a reset, ugh! 73, Charlie, W0YG..>> SN 5366 _______________________________________________ Elecraft mailing list Post to: [hidden email] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com |
> -----Opprinnelig melding-----
> > An example of this is I turn the rig on and say it comes up > on 14.010. I tune up the band to 14.035 and turn it off. If > I turn it back on immediately, it come up back on 14.010! Did you try to wait > 30 seconds before you turn it off? The manual says: "Backup Timer While you're moving the VFO, a 30-second data backup timer is being continuously re-started. Once you have completely stopped tuning the VFO for at least 30 seconds, the K2 will then save your current operating frequency in EEPROM. As long as you stay on a particular frequency, no further updates will be done." 73 Sverre LA3ZA http://www.qslnet.de/la3za/ _______________________________________________ Elecraft mailing list Post to: [hidden email] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com |
In reply to this post by W0YG, Charlie Summers
Charlie,
Don't do that reset!!! The K2 does that if you do not wait long enough at the new frequency. So tune it up to 14.035 again and wait at least 30 seconds (or a full minute) before changing bands or turning power off. It has always been there - you just didn't notice before. 73, Don W3FPR > -----Original Message----- > > Well a problem just started. Regardless of where in the 20M band > I am when > I shut down, it always comes up on the same frequency when I turn the rig > back on. The same is true of other bands. Never happened before. Real > strange. > > An example of this is I turn the rig on and say it comes up on 14.010. I > tune up the band to 14.035 and turn it off. If I turn it back on > immediately, it come up back on 14.010! > > Anyone got any ideas before I do a reset, ugh! > > 73, > > Charlie, W0YG..>> > SN 5366 > _______________________________________________ Elecraft mailing list Post to: [hidden email] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com |
Free forum by Nabble | Edit this page |