Well, the Sub receiver was installed this morning, filters and config
seemed to complete without problem.
However, the Sub-RX does not seem to be getting any signals. I see the
Ant=Main when I use B-Set, so it should be sharing the main antenna.
Any suggestions? Nothing pops out on the CONFIG list, and I had three TMP
cables plugged into the SubRX module, there were only 3 jacks I saw. There
were no unplugged ends inside the case. There was one leftover TMP
cable... I thought it was for the 144 module I don't have. I may have to
open it up and re-check all the TMP cables. Unless it's a simpler fix.
73 de Chuck, WS1L
--
===================
Chuck Chandler
[hidden email]
===================
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]