I've not seen this, but your VFO B area is probably showing power supply voltage when a power level is expected.
Can you save your configuration with the K3 Utility, then perform parameter initialization (EE INIT) then restore configuration? EE INIT is described in the K3 Owners manual.
Dick, K6KR
Sent from my iPhone
On Sep 20, 2010, at 1:50 AM, "Jeff Cochrane - VK4BOF" <
[hidden email]> wrote:
> Hi everyone,
>
> I am attempting to do a TX Gain Calibration and every time that I have attempted it so far, I get the following response from the K3 Utility.
>
> --------------------------------------------------------------------------------
>
>
> Starting 5 watt calibration
>
> Calibrating at 1.900 MHz
>
> Calibration power settled at "13.5 V ;"
>
> Elapsed time: 12 seconds
>
> Tx Gain calibration failed because transmit power did not reach the expected value
>
> 5 watt calibration failed
>
>
> --------------------------------------------------------------------------------
>
> I get the same error if I bypass the 5 watt test and go straight to the 50Watt test.
> I have tried it with the radio running on a battery and with a regulated power supply.
> I am using the latest version of the K3 utility.
>
> Any idea's?
>
> Jeff Cochrane
> VK4BOF
> East Innisfail QLD
> Australia
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
