Before I start tearing things apart, and rewiring connectors I would like to ask if anyone has found an easy way to get +5V from the ACC connector to use for TX Inhibit on pin 7?
Searching the list archive I found that this question was asked before by N1EU:
"Is there a convenient +5V source for
wiring the required pull-up resistor to Aux I/O Pin 7?", no answer to it was found.
I am looking at taking out one of the grounds at pin 5 or 12 and running a jumper from RP2 (10 k resistor chip with unused pins).
I don't want to use the 12VDC out for this purpose.
Niko - AC6DD
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
