Great Don. Thanks!
73,
Mike
N4JX
----- Original Message -----
From: "Don Wilhelm" <
[hidden email]>
To: "Mike Geddes" <
[hidden email]>
Sent: Monday, May 07, 2007 7:23 PM
Subject: Re: [Elecraft] TenTec 701 Hand Mike wiring
> Mike,
>
> You are correct - wire the Yellow lead to pin 1, Black to pin 2, Braid
> to pin 7 and Red to pin 6.
>
> You do not need any resistor on the mic jack, but if you already have a
> 5.6k mounted between pins 1 and 6 (so the Elecraft mics will work), the
> TenTec mike will work fine with it installed.
>
> 73,
> Don W3FPR
>
> Mike Geddes wrote:
>> Greetings Elecrafters! Just received my TenTec 701 hand mike in the
>> mail today, for use with my K2. I am going to jumper the K2 straight
>> across (the Elecraft mode), and rewire the 701 to fit it. Can anyone
>> confirm the wiring on the 701? I think it is:
>>
>> Braid - Ground
>> Black - PTT
>> Red - Power
>> Yellow - Microphone
>>
>> Please confirm if you are able. Thanks in advance.
>>
>> 73,
>> Mike
>> N4JX
>>
>> K1/4 2319
>> K2 6042
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
