Thank you for the help!!

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

Thank you for the help!!

David Steines
Thank you to all those who offered advice on my transmitter alignment problem. It turns out that I had tuned according to the lower power peak for each capacitor, hence the low power output. After scrambling the settings and tuning again, I found a different combination for the inductors, and now I have constant output over 2 watts.

As for the VFO problem, it appears that the capacitor is actually damaged and needs to be replaced. After rechecking the solder joints and still being unable to cure the problem, I removed it from the board and found that part of the underside had melted and apparently burned. As a first time builder, I think I might have held the iron too long or brushed the iron against the capacitor.

Nonetheless, all your advice payed off. Thanks so much for the quick replies and clear explanations--it was a huge help! See you on the air!!

73s

Dave, KB1JHY



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com