Threshold not working in PSK31 in firmware 3.14

[Tom-N2YTF]

Apparently the threshold setting is not working in psk31 in firmware version 3.14 on the K3.  Even the maximum threshold setting of 30 does not prevent random characters from appearing.

From page 33 of the latest manual:

Hold TEXT DEC , then select ON using VFO
B. Below the DATA icon you should now see a
T, showing that text decode is enabled.

• Adjust the threshold (THR) using VFO A. Start
with THR 0. Higher settings prevent text
decode on weak signals or noise. Tap CWT to
exit text-decode setup.

73,
Tom-N2YTF

[KK7P]

> Apparently the threshold setting is not working in psk31 in firmware version
> 3.14 on the K3.

Actually, the threshold control is not working yet in the PSK31 internal
decoder in any version.

On the list, not near the top, though.

73,

Lyle KK7P

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html