I _believe_ that the problem was a sequencing problem ... the 'Low' power configuration menu doesn't show up UNLESS the transverter cables are connected between the K2 and the XVTR. At least, after connecting the tables, rebooting the K2, and accessing the menus a few times ... the 'L 0.01 - L 12.7' menu option showed up.
Thanks for those who replied offline.
------------------------------------------------------------------------------
This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email.
==============================================================================
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
