I am trying to use my K3 to drive a DB6NT
transverter.
I am using the low power output and the Xvtr out
plug.
The transverter is 28mhz input 1296 output. 0-1mw
input power, which suits the K3.
However I cannot get the xvtr to xmit. My problem
is I cannot prove that I am getting any power out of the K3.
I cannot hear any output listening on my Orion II
on 28mhz and I cannot see any signal on the Winradio G315 which is tuned to
28mhz.
I also use the Orion II to drive a DB6NT xvtr on
28mhz, when I key that, I can see the 28mhz signal, howver the Orion has an
output of 10mw, but the signal
is perfectly visible on the Winradi
screen.
My question is therefore, what is the best way to
prove that the K3 is outputting on 28mhz at say 1mw or less, and if not what is
stopping it, as all the config
screens say that the tx is on for the xvtr
output.
Regards to all
Ross
ZL1WN
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
