I tried that but it still does not get the VFO B freq from memory to actual VFO B
73 Paul
I've noticed this when B is not on same band as A. Try A-B and recall your memory again
--
Pierfrancesco Caci
*
* Today at 2:27 AM
To
* paul ecker
* paul ecker
*
[hidden email]
paul ecker <
[hidden email]> wrote:
>I cannot get the K3 scanning function
>to work properly. I am following the instructions in the K3 manual pg
>40
>as well as the Fred Cady book pg. 46. I have used both the Elecraft K3
>Memory Editor
>and entered the memories manually, to save the frequencies into the K3
>memories. When I press M>V, the freqs stored in memory are only being
>recalled to VFO A but not to VFO B. So when I press Scan, no scan
>commences. If
>I program the desired freqs into VFO A & VFO B manually, and then press
>Scan, I get M>V REQ in the display window and no scan start. I have put
>the lower start freq
>in VFO A and the Stop in VFO B. I have also saved the desired mode with
>each
>memory pair.
>
>
>So obviously I am missing something in
>this process but it’s not apparent to me in the manual nor could I find
>in the
>archives. So what am I missing?
>
>
>73 Paul
>kc2nyu
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
