Troubleshooting my K2 U4 on RF board Pin 7 shows 4.8V manual says 0 ?

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

Troubleshooting my K2 U4 on RF board Pin 7 shows 4.8V manual says 0 ?

Clifford Hynds
Troubleshooting my K2 U4 on RF board Pin 7 shows 4.8V DC manual says 0 ?
other pins correct .

Any one confirm this please,

thank you
Cliff VK2CCJ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: Troubleshooting my K2 U4 on RF board Pin 7 shows 4.8V manual says 0 ?

Don Wilhelm-4
Cliff,

That is not a problem - that is the SCK line that you inquired about before.

73,
Don W3FPR

On 1/9/2013 1:21 AM, Clifford Hynds wrote:

> Troubleshooting my K2 U4 on RF board Pin 7 shows 4.8V DC manual says 0 ?
> other pins correct .
>
> Any one confirm this please,
>
> thank you
> Cliff VK2CCJ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html