Tune and CW power levels in version 4.60

[Jack Colson]

I just upgraded to mcu 4.60 and observed that when adjusting the power out on CW to a suitable value to drive an amplifier then switching to tune the power is at almost full (90+watts).  Is this a change from earlier mcu versions or my bad memory?

After setting the tune power out to a lower value and using it at that level the next time you go to use the tune it is back at almost full output.  

Help!
73
Jack, W3TMZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Jack Colson]

Loooooooong Time Rick, Thank you.
On Dec 13, 2012, at 11:29 AM, Jack Colson <[hidden email]> wrote:

> I just upgraded to mcu 4.60 and observed that when adjusting the power out on CW to a suitable value to drive an amplifier then switching to tune the power is at almost full (90+watts).  Is this a change from earlier mcu versions or my bad memory?
>
> After setting the tune power out to a lower value and using it at that level the next time you go to use the tune it is back at almost full output.  
>
> Help!
> 73
> Jack, W3TMZ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html