Although I generally use the 4-band filter board, I intend to convert my
K-1's (#391) original 2-band filter board to 80 & 40 meters from 40 & 20. I
have the 80 meter component kit. Question is: Is it necessary to locate the
80 m parts at the band 1 locations (necessitating unsoldering & relocating
the 40 m components) or may I just remove the 20 m parts and replace with
the 80 m values? Will the on-board I/O controller and MPU care when I
recalibrate and perform the band specification procedures?
Any advice would be appreciated.
Tks & 73,
Jim Gelbort W9TO
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
