Type 31 Ferrite

[Mike Harris-9]

I've got a small stack of 2.5 inch diameter type 31 ferrite rings.
Interestingly the resistance measured on the ring was dramatically
different depending upon which of the flat sides measured.

One side 600kOhm+/- whilst on the other 10>20kOhm. This was the same for
all of them.

Regards,

Mike VP8NO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Jim Brown-10]

This is not unusual. The value is not critical, but rather that the
resistivity is within a range that CAN be measured with a typical VOM.

73, Jim

On Tue,5/23/2017 5:50 AM, Mike Harris wrote:
> I've got a small stack of 2.5 inch diameter type 31 ferrite rings.
> Interestingly the resistance measured on the ring was dramatically
> different depending upon which of the flat sides measured.
>
> One side 600kOhm+/- whilst on the other 10>20kOhm. This was the same
> for all of them.


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]