Tom,
Are the BFO "jumps" more than 20 Hz per 'jump'? The DAC value limit for
the BFO is approximately 20 Hz, so that level of granularity is to be
expected. If you are experiencing jumps greater than 20 Hz, you have a
problem somewhere. Perhaps I can help you localize it off-reflector,
but I need more information to be of assistance.
73,
Don W3FPR
On 11/11/2013 11:31 PM, Tom Field wrote:
> I have been re-aligning my K2 after finishing the K2 100 options. Dial
> calibration and PLL have gone without problem. I'm able to set the LSB/USB
> filters using Cal FIL. When I'm trying to use CAL fil to set the CW
> filters acct N0SS's notes, I can't move the pass band down so the filter is
> set over the 600 hz line. the BFO "jumps" and then starts over again. Any
> Idea what the problem is?
>
>
> Tom F.
> KI6NRD
> Elecraft K2/100 7432
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
