VCO Alignment issue

[kc4wvl]

K2 s/n 4276

VCO Alignment (p61)
VFO set at 4000 kHz
@R30 left side = 0.018 vdc
L30 verified as a 4.7 uH "T005Z"
C72 verified as a 270 pF "271"

Rewound T5
verified primary = 16 turns
verified secondary = 4

Adjusting L30 has no effect on R30 voltage reading.

****************************************************************

Please advise.

Thank You
William Smith
KC4WVL
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

A common cause of that behavior is a solder bridge on the thermistor circuit
board.  Check it carefully at least 3 times.

73,
Don W3FPR

> -----Original Message-----
>
> VCO Alignment (p61)
> VFO set at 4000 kHz
> @R30 left side = 0.018 vdc
> L30 verified as a 4.7 uH "T005Z"
> C72 verified as a 270 pF "271"
>
> Rewound T5
> verified primary = 16 turns
> verified secondary = 4
>
> Adjusting L30 has no effect on R30 voltage reading.
>
> ****************************************************************
>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com