Volunteers needed to test new K3 Utility

[Dick Dievendorff]

I've made significant changes to the K3 Utility over the last few weeks to
exploit new MCU capabilities, and I need a few volunteers to test before
offering this version for general availability.

 

I need people to test firmware load, TX calibration, RF Gain calibration,
configuration save/restore and crystal filter configuration.

 

All functions that access K3 EEPROM (config save/restore, filter
configuration, command macro read/write) are much faster. For example, save
configuration takes 5 seconds.

 

Tx Gain calibration no longer changes the last-used frequency on each band.


 

The new Tx Gain calibration uses different techniques for MCU >= 3.97 and
earlier than 3.97. I need some testers for both before and after 3.97.

 

If you can help, please send a note to [hidden email] or
[hidden email].  


Thanks!

 

Dick, K6KR

 

 

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html