I had a situation where the W2 watt meter would flash the LEDs on power
up, then I was not able to communicate with it via the RS232 cable.
After repeated attempts, I was able to quickly press the LED on/off
button on the software during power up to make it come back to life. I
had to press this button during the power up cycle or the W2 would not
respond. Evidently the LED button got pushed by accident, but it put
the W2 in an inoperable mode that required a site visit to our remote
base location.
Has anyone else experienced this? Probably most people never use this
feature.
73, Joe, K1ike
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
