OK,
I found out that I put out too much power with my
XV144. This is because I did alignment with 12V and
later ran the rig with 13,8V.
I did two things to nearly solve the problem of
overheating my XV144.
1st I realigned power with 13,8V
2nd I disassembled the chassis, removed the heat
rubbers between the power module, heat spreader and
bottom cover. Then I applied heat-conductive paste in
both places.
So power is now lower and the heat is very much better
spread on the bottom cover. You can feel that.
Nonetheless, there is a point in time after maybe
15min of continous CW CQ where the XV shuts down due
to heat. But this is heavy contest use and a fan is
appropriate/acceptable in this scenario, I think.
73
Gerhard
___________________________________________________________
Gesendet von Yahoo! Mail - Jetzt mit 1GB Speicher kostenlos - Hier anmelden:
http://mail.yahoo.de_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
