WTB: EC2 Enclosure and KAT100 PNL

[N7DXT]

Hello,
I am going to assemble the K2 Twins.  If you have a spare enclosure for
Panel kit for the project let me know.

Thanks for looking
Gary Watson
N7DXT
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Don Wilhelm]

Gary,

Elecraft has the KAT100PNL kit with all parts (including the Font and
rear panels) to convert a KAT10001 to a KAT100-2.  You will also need
the EC2 enclosure kit if you do not already have one.  You may also want
the Tilt stand unless you plan to use the combination flat on a shelf.

You will also have to have the KIO2 (or suitable replacement) to carry
the K2 internal control signals to the KPA100/KAT100.  The required
cable is the same as the normal cable to the KAT100 (see the KAT100 manual).

73,
Don W3FPR

On 5/31/2017 7:01 PM, Gary Watson wrote:
> Hello,
> I am going to assemble the K2 Twins.  If you have a spare enclosure for
> Panel kit for the project let me know.
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]