I am looking for someone willing to troubleshoot and finish my K2, s/n
5567. I have completed the project up to the "Alignment and Test, Part
II", page 60. At step 3 of the 4MHz Oscillator Calibration I get a
reading of 12600 kHz instead of the expected reading of 12090 kHz. It
has almost been a year since the error and I have been unable to resolve
the issue. I spent the last couple of days redoing every step in the
building of the RF board, checking for proper components and soldering.
But the results are the same 12600 kHz.
Although I have enjoyed the building experience I have decided I would
much rather be spending my time using my K2 then troubleshooting errors.
Therefore I am looking for a builder willing to troubleshoot the error
and finish the construction of the K2 and a SSB module. I will be more
than happy to reimburse the person for their efforts.
Please contact me directly via email.
Thanks
Terry
VA6MAC
************************************************************************
This e-mail message is intended only for the person(s) named above and
may contain confidential or privileged information. If you are not the
person named or have not been authorized by them to access their mail,
please notify the sender immediately and delete this e-mail and any
attachments without reading, saving, or forwarding.
************************************************************************
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
