XG1 LEDS

[G4BUE]

I am building the XG1 receiver test oscillator and wonder if somebody
can please tell me if the three leds should be seated flush on the
PCB?

When I insert them, I see a notch in each lead which causes them to
stop about a quarter of an inch above the board.

Thanks and 73 de Chris, G4BUE


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[David Pratt]

I assembled my XG1 with the LEDs pushed in as far as the notch and they
look fine.

73 de David G4DMP
G-QRP 11046

In message <4399D37A.15183.2BC89C1@localhost>, Chris Page
<[hidden email]> writes
>I am building the XG1 receiver test oscillator and wonder if somebody
>can please tell me if the three leds should be seated flush on the
>PCB?
>
>When I insert them, I see a notch in each lead which causes them to
>stop about a quarter of an inch above the board.



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com